Suction truck common three kinds of fault repair methods
Ningbo Xuanchang Electric Co.,Ltd. , https://www.xuanchangpurifier.com
First of all: The tires are tied and the tires are tied. This is the most common fault we have encountered in the suction truck. Faced with the tires, many of our drivers’ friends will find a small repair shop on the road to repair it. This is very easy. For our suction trucks, there are potential safety hazards. Here, we recommend you to use a small suction truck. It is best to go back and find a professional repair shop to check. If you have tires, if you have spare tires, We can choose to change tires in order to save time.
Second: brake failure Facing brake failure, a small suction truck teaches you a few ways to solve this problem: 1 Stepping on one foot doesn't work well, but when you pedal several times in succession, the braking effect is very good. The free travel of the pedal is too large or the brake gap is too large. Should adjust the pedal free stroke, and then check the brake gap, if necessary, disassembling the brake repair; 2 continuous depressing the brake pedal, such as the pedal gradually increased and a feeling of elasticity, but after a little pause and then step on the pedal is still very low, That is, there is air in the brake system. At this time, the brake system should be exhausted. 3 When the brake pedal is pressed, it is not weak or sink, but it is a bad braking effect. This phenomenon is a wheel brake failure, such as braking. The shoe has oil or poor contact, aging of the friction plate, wear, uneven wear of the brake drum.
Finally: Fuel consumption soars. If you suddenly find that the fuel consumption of the Dongfeng suction truck is much higher than usual, then it will cause the driver of our truck driver to pay attention. We must first find out the reasons for the increase in fuel consumption. Let the right medicine. If the clutch of the suction truck slips, the tachometer of the engine will increase, but this is a very slow speed. In this case, we can judge that the clutch of the suction truck has slipped, and we need to replace the clutch plate. Clutch Platen and wheel.