How to seal the Jetta door seal, how to paste the Jetta door seal

I bought Jetta for a while, and I started to tangled the door seals badly. Every time I walked the dirt road or the dirty road, I came back to the door pedal and there must be a lot of dirty soil. And the noise is louder when driving at high speed. After a while, the car found that there was a little bit of dust inside. So I thought about putting a seal on the door to better care for the car. In the end , how to get the Jetta door seal ? Here is the installation procedure to learn.

I only bought the P type, and the Z type. In fact, the position of the B-pillar should be sticky to the small D-shape, which can be seen in the figure below.

blob.png


This is the P type, bought 6 meters, used in the front two doors, and 2 back doors. The last part is hand-pruned and used in the B-pillar, which can be seen below.

blob.png


This is the Z type, bought 2 meters, used in the A column position. However, the store may have given a little more, and I have no specific amount. There is still a little left after the installation.

blob.png


Before installation

blob.png


Need to pay attention to the flow tank under the door, to leave the position when installing,

blob.png


Usually look at the installation map in the online store. When installing the following, it is cut into a section. There are 4 water holes under the front door. If you cut it, you should cut it into 5 sections. . . . .

blob.png


blob.png


This is the position of the side of the front door. I didn't buy a small D-type, but just the P-type left, I cut it and used it on the side of the front door.

blob.png


The P-type is cut and mounted on the side of the front door. Because it is not specifically glued here, so close the door after installation, so cut a small vent hole at a distance, now the door closing effect is very good, there is a heavy sound, and not so tight. A little admire myself haha.

blob.png


After installation

blob.png


blob.png


These are the detailed steps of the Jetta door seal . I hope that it will help you. At the same time, you can exercise your own hands-on ability. You can go to the 4S shop for maintenance, because it is necessary to repair as a qualified owner. Have you learned it?


Color Coated Coil

Color coated steel coil using hot-dip galvanized steel strip as the base material of color coated steel strip in addition to zinc layer protection, zinc layer on the organic coating plays a covering and protection role, prevent steel belt rust, service life is longer than galvanized strip, about 1.5 times. Color COATED COIL HAS LIGHT, BEAUTIFUL AND GOOD ANTI-corrosion performance, and can be directly processed, the color is generally divided into gray and white, sea blue, brick red, mainly used in advertising, construction, home appliances, electrical appliances, furniture and transportation industry.

Color Coated Coil,Color Coated Galvanized Steel Coil,Color Prepainted Galvanized Steel Coil,Colour Coated Coil

Shandong Panhua Metal Material Co. LTD , https://www.panhuametal.com