Longgong Ruifan De Company's drive shaft product development has a quick effect
Differential Cap, Differential Vent Cap, Differential Part Ningbo Xiangsheng Auto Parts Co., Ltd. , https://www.partsaa.com
In order to successfully complete the development of the drive shaft products, all employees of Ruifande Company have worked hard. The chairman and general manager of the company pay close attention to all aspects of the development of the drive shaft products, and provide guidance opinions in a timely manner, and also personally preside over market research and product process demonstration. When the company does not have the conditions such as the site and equipment, the technicians try to squeeze out a small piece of the site from the steel pipe section for product development and development. From sample trial production, performance testing to small batch trial production, tracking verification until mass production is formed, it takes less than half a year. By April of this year, it has formed an annual production capacity of 30,000 sets of a total of 17 types of construction machinery drive shafts, 100% to meet the supporting needs of the holding company's mainframe, showing the snail shell as a dojo, small stage singing drama Effect.
The company always adheres to the principle of saving cost and diligent business, and always pays attention to saving costs, reducing costs, and achieving low input and high output. In addition to the introduction of international famous brands in key equipment, the company's other equipments are domestic famous brand equipment. Among them, auxiliary facilities, fixtures and station tools are all designed and produced by themselves, which greatly reduces the investment in product development and speeds up product development. The drive shaft section set up by the company, from personnel recruitment to on-the-job operation, fully realizes independent training, with the old and new, rolling development. It not only guarantees the quality of the products, but also meets the requirements of the products. At present, the drive shaft section has formed two production lines for drive shaft assembly and spraying.
The company will adjust the existing production layout, increase investment in technological transformation, fill in some key equipment (including key test equipment), improve the company's production capacity, and aim to produce 50,000 sets of engineering machinery drive shafts per year. Sprint.