Sprinkler device introduction
Second, IIM-130B sprinkle a red car Aluminum Tread Plate,Aluminium Tread Plate Five Bar,1100 Aluminium Tread Plate,1100 Aluminum Tread Plates Zhengzhou Yearshine Industry Co., Ltd , https://www.zzyscorp.com
Outline drawing of IIM-130B Sprinkler (without sweeping device). The basic vehicle is the 3HJ1-130 chassis. The working device includes: water tank, mesh filter, main valve, water pump, and pipe with two nozzles. Road system. In winter, the plow can be installed on the car. When the sprinkler works, some of the power is transmitted from the engine via the transmission to the driving system to drive the vehicle to travel. In addition, part of the power is transferred to the pump through the transfer case.
When the sprinkler is in the transport state, the transfer case handle is in neutral and the pump does not work. When the sprinkler sprinkles water, the water pump absorbs water from the water tank, and the pressure water is sent to the sprinkler behind the vehicle through pipelines and valves. One way to add water to a water tank by a sprinkler is to fill it directly with a fire faucet. Another method is to use a water pump to pump water from the pool.
Sprinkler pipe connection principle. The pump 4 can be used for adding water to a water tank or as a water pump. When the water is added to the water tank, the valve 12 closes and the valves 10, 11 open. The pump absorbs water from the suction port 13, and sends the water to the water tank 1 through the valve 11. During the watering operation, the valves 10, 11 are closed and the valves 12, 5 are opened. The pump pressurizes the water in the tank and sends the sprinkler 7 and 90 behind the vehicle through the pipe. The water level of the tank is indicated by the level sensing element 2. At the end of the sprinkling operation, the water in the water tank is drained through the drain valve 14 . Throttle valve 5 is used to adjust the flow of the spray water, thereby adjusting the amount of water spray and the width of the spray.
â–².Power take-off
Sprinkler power take-off consists of box, gear, bearing, spline shaft and accessories. The double gear of the power takeoff is driven by the four gears of the main transmission of the automobile, and the power is transmitted to the output shaft and then the water pump is driven by the transmission system.
â–². Water tank
Sprinkler tanks are cylindrical tanks, which consist of tanks, brackets, and tank lids. The tank top diameter of the tank is 450mm, and the tank compartment structure divides the tank into three single tanks, and water circulates through the semicircular hole at the bottom of the diaphragm. There is a 50 nun drain pipe at the bottom of the tank body, and there are 2 vent holes with a diameter of 20 mm on the tank cover.