Tanker user manual and installation method
1. To ensure the tank truck is clean, the tank and oil system should be cleaned periodically. The inner and outer joints at both ends of the oil hose should be coated with lubricating oil. The tank truck can be easily disassembled and installed. After each time the tubing is completed, clean it in time to ensure that it is clean inside! 2. The use and maintenance of the tanker oil pump is strictly performed according to its use and maintenance instructions! 3, before refueling operations, must use the plug to insert moisture into the wet land, the tanker grounding tape should be grounded, the operation process should always maintain good static conduction! 4. Tanker safety valves and filter nets should always be checked and cleaned! 5, tanks and piping systems should be cleaned regularly. The tanker regularly checks whether the joints of the pipeline system are well connected and the seal is reliable! 6: The tanker should be installed in accordance with the provisions of the electrostatic belt, when the static electricity encountered in the car concentration of highly flammable gas, an explosion occurred, the electrostatic belt for the car body and other friction is frequent, easy to produce static electricity space can effectively go out Electrostatic hazards to ensure that the body is not compromised. installation method: Installed in the chassis metal parts! After a period of wear, the rubber band on the top can be put down! Conditional users can install electrostatic tanker grounding alarm Under the high-voltage wires, it is forbidden to add fuel to the tanker. Never use the hanging fire method. Sometimes the spark plug of a car will have carbon deposition. When a certain cylinder's carbon deposition is serious, the cylinder will not work properly. In order to make the cylinder work normally, the method of “hanging fire†outside the cylinder is adopted (leaving the spark plug and the high voltage wire 3 Mm - 4 mm gap) to improve the energy of the spark plug electrode flashover, so that the cylinder back to work, but the general "hanging fire" method is not easy to fall off with little attention. If there is dripping gasoline on the cylinder, it is extremely easy to have a fire. Therefore it is only a temporary remedy. The correct treatment should be timely cleaning and maintenance of spark plugs, try to avoid the use of "hanging fire" method. Preparation of tanker before use 1. Insert the conductive rod into the ground to make it "grounded". If the ground is dry, it can be watered to make it wet, ensuring good grounding. Check the ground chain to make contact with the ground. 2. Open the tanker control box door and check the valve handles to make them closed (vertical position). 3. When using the oil pump for the first time, there is no oil in the pump and it is necessary to add oil in advance. 10 liters of oil can be added through the oil inlet. 4. Check the lubricant oil level in the gearbox to the lower edge of the grease plug hole. If insufficient, add gear oil. 5, check the gearbox lever, so that it is in a neutral position, check the position of the power lever control handle, so that it is horizontal to the right position, check the throttle controller to make it the smallest. Bathroom cleaner is a type of cleaning product that is specifically designed to clean and disinfect various surfaces in the bathroom. It is typically used to remove dirt, grime, soap scum, and other types of stains from surfaces such as sinks, toilets, showers, and tubs. Bathroom cleaners may contain a variety of active ingredients, such as bleach, hydrogen peroxide, or ammonia, which help to break down and remove stubborn stains. Some bathroom cleaners also contain fragrances or essential oils to leave a pleasant scent after cleaning. It is important to follow the instructions on the product label carefully when using bathroom cleaners, and to always use them in a well-ventilated area to avoid inhaling fumes.The bathroom is a place for everyone to take a bath. Now people will also divide a separate area in the bathroom to make a shower or bathtub. No matter whether it is a shower or bathtub, after a long time of use, the surface will be stained with some scale, which needs to be cleaned in time. If the scale is not cleaned, there will be a lot of bacteria in the shower or bathtub, which will not only affect the aesthetic degree, It is also a threat to people's health. Cleaning scale and other things need to use bathroom cleaner. Today we will introduce bathroom cleaner specifically. Bathroom Cleaner,Glass Cleaner Spray Kit,Glass Cleaning Spray,Toilet Odor Remover Jiangyin yinghuameng Houseware Co.,Ltd. , https://www.nbcare-guys.com
Bathroom cleaner, containing organic acid compounds, has the function of removing rust stains, scale, urine stains, oil stains and soap stains. It can be widely used to clean the stains such as bathtubs, wash basins, urinals, toilets, porcelain plates, tiles, mosaics, terrazzo, and papyrus stones.