Cause Analysis and Solution of Common Self - priming Pump Faults

Self-priming pump failure one:

Analysis 1) no water or intermittent water, less water.

Solution â‘  motor is not started, eliminate circuit failure;

â‘¡ pipeline blockage, remove blockage;

â‘¢ pipeline rupture, welding repair or change;

â‘£ filter plugged, remove clogs;

⑤ suction port exposed water, if the pump is still not effective under the discharge? Trace ㄒ hazelnut?

â‘¥ electric pump reversal, replace the power line phase sequence;

⑦ pump housing seal ring, impeller damage, replacement of new parts.

Cause Analysis and Solution of Common Self - priming Pump Faults

Self-priming pump failure two:

Cause Analysis 2) The motor can not be started with buzz.

Solution â‘  a phase circuit, repair lines;

â‘¡ bearing axle, repair or replacement;

â‘¢ impeller with foreign body and pump stuck, remove foreign body;

â‘£ low voltage, adjust the voltage.

Self-priming pump failure three:

Analysis 3) the current is too large, ammeter pointer swing.

Solution â‘  rotor sweep bore, replace the guide bearing;

â‘¡ shaft and bearing relative rotation is not flexible, replacement or repair bearings;

â‘¢ due to severe thrust bearing wear, leaf rotation and seal ring phase, replace the thrust bearing or thrust plate;

â‘£ axis bending, bearing different heart, send repair shop repair.

Self-priming pump failure four:

Reason analysis 4) Insulation resistance of motor winding to ground is low. Motor windings and cable connectors or cables are damaged, replace windings, repair connectors or cables.

Recuperator

Recuperator,Rbsic Recuperator,Sisic Recuperator,Heating Systemsheatcor

Jiangsu Kinuo Furnace Roller Co., Ltd. , https://www.jskinuoroller.com