How often does the crusher require a minor repair cycle?

In the mission, the conical stone breaker should be averaged and cannot be segregated. If the feed is not uniform, the consumption will drop, the product will be oversized, the springs will move frequently, the bowl bearing pressure will be high, and the power consumption will rise.

Every time we run a certain time, we can properly review and train the equipment so that we can maintain a better operating condition of the equipment after continued consumption and achieve better production capacity and product quality.

The minor repair cycle is conducted once every two weeks to one month. The content includes:

1, review bowl-shaped tiles;

2. Review the wear of taper sleeves and straight sleeves and review their clearance.

3, review the bevel gear meshing gap;

4, review the drive shaft gap.

The cone-type crusher should be equipped with iron removal to avoid grinding the iron in the grinding chamber. If there is frequent over-iron, it can cause a broken shaft incident. To spend at full capacity, otherwise the product will appear coarse. The ratio of grinding in the consumer line is reasonable, so that the effectiveness of the grinding machine can be maximized. Spring pressure can not be too tight, too much pressure will also break the shaft incident, the pressure is too small spring will frequently beat, affect the normal tasks of the grinding machine, and the product size becomes coarse. Smooth oil temperature should not be too high or too low, otherwise it will affect the electromechanical operation. Smooth oil should always be changed, not too dirty, too dirty will reduce the wear of gears and bowl-shaped tiles, bushings, etc., and even make shaft sleeve death. The drive belt can not be installed too tightly, otherwise it will cause the drive shaft to rotate not smart or break. It should not be too loose, otherwise it will cause a grinding machine sloppy car. The cone crusher feed should not be too wet and sticky, fine particles should not be too much, nor too large, otherwise it would cause boring cars. Grinding machine discharge port deposit can also cause boring cars.

Conical grinding machine because of its unruly operating environment, dust, combined with some protection of the unit is not in place, often in the operation of a variety of problems, individully speaking, the operation of the cone crusher should pay attention to the following issues before Protection of electrical and mechanical normal operation.