How to maintain hydraulic lifts
Over time, motorbikes have also developed many new models and started to use electric energy. The motorcycle now is not only a traffic tool, thanks to its power and hard shell, it also performs well when used for off-road sports, inevitably, the Motor Seat surfaces are damaged during driving in the wild. This product is the replaceable Motorcycle Seat, many people buy it to replace the old one. It matches with the Enduro E-Bike Seat, easy to disassemble, clean and breathable, made of PVC leather and steel frame, filled with sponge, much less likely to be scratched than a leather surface. Every E-bike Seat was tested the quality before sell, welcome to contact us if you have requirements. Motorcycle Seat,Motor Seat,Enduro E-bike Seat,E-bike Seat,bike seat,BMX seat,fixie seat,MTB seat Suzhou Jingqiyao Intelligent Technology Co., Ltd. , https://www.jingqiyaoparts.com
1, daily maintenance (per shift).
2. After 1500 hours of lift operation, minor repairs were made to the mechanical and electrical systems.
3. After 5,000 hours of work on the lift, the mechanical and electrical systems were repaired.
4. After 10,000 hours of work on the lift, the mechanical and electrical systems were overhauled.
Second, the hydraulic lift machinery and equipment maintenance and maintenance:
1. The brakes of various agencies should always check and adjust the clearance between the brake shoes and brake wheels to ensure flexibility and reliability. On the friction surface, there should be no dirt, dirt must be washed off with gasoline or thinner.
2. Lubrication of gearboxes, gearboxes, external gears, etc., as well as hydraulic fluids are performed according to the requirements in the lubrication table.
3. Attention should be paid to checking whether there are broken wires and loose strands in the wire ropes of various departments. If it exceeds the relevant regulations, it must be replaced immediately. The maintenance of wire ropes should strictly comply with the provisions of GB5144-85.
4. Check the connection of each department frequently and tighten it if loose. The body connection bolts should be checked for tightness when the body is stressed (rotating arms can be used to create compression). All connecting shafts must have cotter pins and must be fully opened. Flange ball valve 5. Regularly check whether each agency is operating normally and whether there is noise. If any fault is found, it must be promptly removed.
6. When installing, removing and adjusting the rotary mechanism, it is necessary to ensure that the centerline of the reducer of the rotary mechanism is parallel to the centerline of the gear, the mating surface is not less than 70%, and the meshing clearance should be suitable.
7. Always check all wires and cables for damage. Should be timely dressing and replacement of the damaged part.
8. In case of motor overheating, it is necessary to stop in time, and then continue to operate after eliminating the fault. The lubrication of motor bearings should be good.
9. Each part of the brush, its contact surface should be kept clean, adjust the brush pressure so that its contact area is not less than 50%.
10. Each control box, distribution box, etc. are often kept clean, and dust on electrical equipment is cleaned in time.